Product Description
User's Guide
1. Clean all surfaces thoroughly. Remove old gaskets and prepare flange surfaces. Dry and remove all oil and grease.
2. Remove the cap, puncture inner seal of the tube, screw on nozzle and cut the nozzle to desired size.
3. Apply continuously uniform 1~4mm bead around perimeter of one surface. Completely surround all bolt holes.
4. Wait about 10 minutes for silicone to "skin over"; then re-assemble the parts.
5. Silicone dries in 1 hour and allow 24 hours to fully cure and bond.
Notes
1. Leave thickness for gasket when re-assembling. Don't over-tighten the bolts.
2. Acidic silicone releases acetic acid (vinegar-like odor). Use with adequate ventilation.
3. Put back the cap after use.
1. Clean all surfaces thoroughly. Remove old gaskets and prepare flange surfaces. Dry and remove all oil and grease.
2. Remove the cap, puncture inner seal of the tube, screw on nozzle and cut the nozzle to desired size.
3. Apply continuously uniform 1~4mm bead around perimeter of one surface. Completely surround all bolt holes.
4. Wait about 10 minutes for silicone to "skin over"; then re-assemble the parts.
5. Silicone dries in 1 hour and allow 24 hours to fully cure and bond.
Notes
1. Leave thickness for gasket when re-assembling. Don't over-tighten the bolts.
2. Acidic silicone releases acetic acid (vinegar-like odor). Use with adequate ventilation.
3. Put back the cap after use.
Additional Information
| Product Model | 6598 |
| Appearance | exquisite and well-proportioed paste, no agglomeration, no geling and no surface solidiyfy |
| Full Curing Time | 24 Hours |
| Tensile Strength (MPa) | Acidic ≥ 1.80; Neutral ≥ 1.20 |
| Package Size | 85 g/blister (3 oz/blister) |
| Elongation | Acidic: ≥ 250%; Neutral: ≥350% |
| Shores Hardness | 35 ~ 45 |
| Tack-free Time | ≤ 15 minutes |
| Sag | ≤ 2.5 mm (0.1 inch) |
Product Tags
Add Your Tags:
Use spaces to separate tags. Use single quotes (') for phrases.